Oil Pump Drive Chain - INGENIUM I4 2.0L Petrol - PHEV (G2748117): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: VEHICLE RECOVERY
Disconnect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Remove the oil pan.
Refer to: OIL PAN - INGENIUM I4 2.0L PETROL - PHEV
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Use the special tool to hold the oil pump drive sprocket.
  Special Tool(s): 205-053
- Remove and discard the bolt.
- Remove the oil pump drive chain and sprocket.