Lower Timing Cover - INGENIUM I4 2.0L Petrol (G2344486): Installation

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- The lower timing cover must be installed within 7 minutes of applying the RTV sealant.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Apply a continuous 3 mm bead of suitable RTV sealant in the illustrated areas.

Refer to: SPECIFICATIONS
CAUTION: Take care not to damage the cylinder head gasket when installing the lower timing cover.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the lower timing cover.
- Make sure the locating dowels are installed correctly.
- Install and tighten the 2 bolts.
  Torque : 5 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install 2 more bolts as illustrated and tighten the 4 bolts to the correct torque.

Torque : 25 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install and tighten the remaining 12 bolts.

Torque

M8x35: 25 Nm

M8x30: 25 Nm

M6x30: 12 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Reposition the CKP sensor into the correct location.
- Install the clip.
- Install and tighten the bolt.
  Torque : 8 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the clip.
Install the crankshaft rear seal.
Refer to: CRANKSHAFT REAR SEAL - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Check the engine oil level and top up if necessary
Refer to: SPECIFICATIONS