LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Defender 110 S >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - INGENIUM 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV -- Defender/L663 (1 Of 2) >> Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2344339) >> Removal And Installation >> Engine Front Cover - INGENIUM I4 2.0L Petrol (G2173203) >> Removal

Engine Front Cover - INGENIUM I4 2.0L Petrol (G2173203): Removal

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: JACKING AND LIFTING

  2. Disconnect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  3. Vacuum drain the engine oil.

    Refer to: ENGINE OIL VACUUM DRAINING AND FILLING 

  4. Remove the crankshaft pulley.

    Refer to: CRANKSHAFT PULLEY - INGENIUM I4 2.0L PETROL 

  5. NOTE: Note the installed position of the components prior to removal.
    G12004565Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the 2 covers.
    • Remove the 2 bolts.
    • Remove the 2 idler pulleys.
  6. G12004566Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the 12 bolts.
    • Remove the engine front cover.
scientia non olet · About LEMON Manuals