Crankshaft Rear Seal - INGENIUM I4 2.0L Petrol - PHEV (G2748108): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Position the new crankshaft rear seal and plastic alignment spacer provided (A) onto the crankshaft and partially install the crankshaft rear oil seal on the crankshaft using the special tool.
  Special Tool(s): JLR-303-1632
- Remove the special tool.
  Special Tool(s): JLR-303-1632
Remove the plastic alignment spacer.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Use the special tool to install the crankshaft rear seal.
  Special Tool(s): JLR-303-1632
- Remove the 2 bolts.
- Remove the special tool.
  Special Tool(s): JLR-303-1632
- Make sure the crankshaft rear seal is correctly installed.
Install the dual mass flywheel.
Refer to: REMOVAL AND INSTALLATION .