Oil Supply Pipe (G2401841): Installation

- Install 2 new sealing washers to the oil supply pipe.
  Renew Part: Oil supply pipe sealing washers Quantity: 2 .
- Connect the oil supply pipe to the oil filter housing.
- Install and tighten the bolt.
  Torque : 18 Nm
- Install 2 new sealing washers to the oil supply pipe.
  Renew Part: Oil supply pipe sealing washers Quantity: 2 .
- Connect the oil supply pipe to the turbocharger.
- Install and tighten the bolt.
  Torque : 18 Nm
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Check and if necessary top-up the engine oil.
Refer to: SPECIFICATIONS