LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2020 >> Defender 110 S >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV -- Defender/L663 >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2344342) >> Removal And Installation >> Charge Air Radiator Coolant Pump (G2415250) >> Installation

Charge Air Radiator Coolant Pump (G2415250): Installation

  1. NOTE: This step is not required if the component is removed for access only.

    Install the charge air radiator coolant pump to the bracket.

    • Install the charge air radiator coolant pump and bracket to the cooling fan shroud.
    • Install and tighten the bolt.

      Torque  : 7 Nm 

    • Connect the electrical connector.
    • Connect the 2 coolant hoses.
    • Install the 2 hose clamps.
    • Remove the 2 hose clamp tools.
    • Reposition the coolant hose into the correct location.
    • Install the clip.
  5. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals