Head Up Display

The HUD  receives a permanent battery voltage supply through the PJB. A HS CAN HMI  systems bus connection allows the HUD  to communicate with other modules. The IPC  virtual display is also connected to the HUD  through APIX2.

The HUD  is controlled from the message center menu.

When selected, the menu offers the following options:

• Selecting the position of the display on the windshield.
• Selecting the brightness of the display.
• Selecting which information is displayed on the HUD  .

Control of the display brightness can be adjusted in 3 different ways:

• As listed above, manually, from within the HUD  selection of the 'Main Menu' in the message center.
• When the vehicle lighting is switched on, the HUD  display adjusts simultaneously with the manual adjustment of the IPC  dimmer.
• Automatic brightness, controlled using data from the rain/light sensor.

The HUD  showroom mode is controlled from the IPC  service menu and displays example images on the windshield when the vehicle is stationary.

Prior to selecting the HUD  windshield position the user should select their desired seating position. The steering wheel controls are used to set the horizontal position of the windshield display. When set, the information can be saved in the seat memory control system, storing the selected preferences.