Left Upper Arm - [+] MHEV (G2328376): Installation

Install the upper arm.
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
- Install and tighten the upper arm front nut.
  Renew Part: Upper control arm nut(s) Quantity: 1 .
  
  Torque : 60 Nm
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
- Install and tighten the upper arm rear nut.
  Renew Part: Upper control arm nut(s) Quantity: 1 .
  
  Torque : 60 Nm
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
- Install the upper arm to knuckle nut and bolt.
  Renew Part: Upper control arm retaining nut and bolt Quantity: 2 .
  
  Torque : 70 Nm
Install the height sensor.
Install the front left wheel arch liner.
Refer to: FENDER SPLASH SHIELD
Install the left air filter housing.
Refer to: LEFT AIR FILTER HOUSING
Use the Jaguar Land Rover approved diagnostic equipment, partially pressurize the air suspension system.
Refer to: AIR SUSPENSION - MANUAL CONTROL PROCEDURE
- Lower the vehicle to the floor.
- Use the Jaguar Land Rover approved diagnostic equipment to fully pressurize the air suspension system.
  Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE