Standard Speed Control

WARNING: This page is about a different variant/trim than selected.

The speed control system is integrated with the engine management system and uses torque control to automatically maintain a set vehicle speed. When engaged, the system can also be used to accelerate the vehicle without using the accelerator pedal.

The speed control system comprises the following main components:

'SET +' and '-' (SET/increase speed and decrease speed) switches - Located on right steering wheel switchpack.
'RESUME' switch - Located on right steering wheel switchpack.
'CANCEL' switch - Located on right steering wheel switchpack.
Clockspring (CLKSPG).
Speed control warning indicator in Instrument Cluster (IC).

The speed control system uses inputs from the following:

Brake pedal switch
APP sensor
PCM
ABS .

The speed control is operated by the driver using only the speed control switches on the right steering wheel switchpack. When speed control is active, the PCM regulates the output signals to the fuel injectors. Thereby the PCM controls the fuel supply as required to maintain the set speed.

During speed control operation, the PCM controls the vehicle speed by adjusting the fuel injection duration and timing. When the accelerator pedal is pressed with speed control active, the APP sensor outputs the signal for the PCM . Then the PCM outputs a calculated throttle angle signal in place of the actual throttle angle signal. The calculated throttle angle is derived from fuel demand based on the torque required to overcome the rolling resistance (vehicle motion drag).

The minimum set speed for speed control is 32 km/h (20 mph).

Speed control is automatically suspended if the following conditions apply:

Vehicle speed falls below 24 km/h (15 mph).
The brake pedal is pressed.
The 'CANCEL' switch is operated.
Neutral, park or reverse gear is selected.
The Electric Park Brake (EPB) is applied.
The difference between actual speed and the set speed is too great.
If the accelerator pedal is used to accelerate beyond the set speed for too long (more than 5 minutes).
The ABS logs a DTC fault.
System error causes shut-off.
All Terrain Progress Control (ATPC) is selected.

There are 4 standard speed control switches located on the right steering wheel switchpack:

'SET+' switch - Increase speed
'-' switch - Decrease speed
'CANCEL' switch
'RESUME' switch.

The standard speed control switches are located on the right steering wheel switchpack. The right steering wheel switchpack transmits the data to the Body Control Module/Gateway Module (BCM/GWM). The right steering wheel switchpack uses a LIN connection to the BCM/GWM. The BCM/GWM passes the data onto the FlexRay bus and to the HS CAN chassis systems bus.