Fuel Tank And Lines - TDV6 3.0L Diesel/TDV6 3.0L Diesel - Gen 1.5/TDV6 3.0L Diesel - Gen 2 (G1606151): Specifications
WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Fuel system | Mechanical - recirculating |
| Fuel tank | Multi layer plastic |
| High pressure fuel pump | Located at rear of engine between the cylinder heads, belt driven from the camshafts |
| Low pressure fuel pump | Dual stage electric - submersible - located in fuel tank |
| Fuel cooler | Located on the left front suspension top mount assembly |
| Fuel filter | Remotely located on the left front suspension top mount assembly - equipped with a renewable element |
| Fuel tank sender units | Two - active and passive - passive sender unit is attached to the removable retaining bracket and the active sender unit is attached to the fuel pump swirl pot |
| High pressure fuel pump maximum operating pressure | 1650 bar - 23931.2 lbf/in2 |
| Low pressure fuel pump operating pressure | 0.5 bar - 7.25 lbf/in2 |
| Maximum fuel pressure to fuel filter | 0.6 bar - 8.7 lbf/in2 |
TORQUE SPECIFICATION
| DESCRIPTION | NM | LB-FT | LB-IN |
|---|---|---|---|
| Fuel cooler retaining bolts | 9 | - | 80 |
| Fuel tank internal bracket retaining bolt | 7 | - | 62 |
| Fuel tank filler pipe retaining nuts | 9 | - | 80 |
| Fuel tank filler pipe hose clamp | 3.5 | - | 31 |
| Fuel tank shield retaining bolts | 45 | 33 | - |
| Fuel tank shield to fuel tank bolt | 10 | 7 | - |