Diesel Exhaust Fluid Level Check And Top-Up (G1935237): Adjustment
- Make sure to add 1 liter of fluid to the upper tank and drain it through the clear hose, if the DEF dispensing kit is being used for the first time.
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustration showing certain components removed to provide extra clarity.
The following step(s) applies to:
Using JLR approved equipment: JLR-F00100010
- Using the JLR
approved diagnostic equipment, follow the on-screen instructions and check the DEF
level.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
CAUTION: Failure to complete this instruction may cause damage to the vehicle.
Check the quality of the DEF using a hydrometer.
-
WARNING: Failure to complete this instruction may result in personal injury.
Make sure the operating levers of the DEF dispensing kit are in the positions indicated.
-
CAUTION: Make sure that the DEF dispensing kit flow meter is reset.
Check the gauge.
-
CAUTION: Make sure that the upper tank is not overfilled. Observe at all times.
Fill the upper tank to the correct amount of DEF previously specified by the JLR approved diagnostic equipment.
-
CAUTION:
- Failure to complete this instruction may cause damage to the vehicle.
- If any DEF is visible in the clear filler pipe, this must be drained and discarded before proceeding to the next step.
Make sure that the inner rubber feed hose is in the position shown.
-
CAUTION:
- Make sure the DEF dispensing kit is correctly installed onto the DEF filler pipe.
- Make sure that the vehicle paintwork is protected.
Install the DEF dispensing kit on to the DEF filler pipe.
-
CAUTION: Do not overfill the vehicle.NOTE: Fluid may be visible in the outer hose.
Position the DEF dispensing kit upper operating lever in the position indicated. The DEF tank top-up procedure will now commence. Immediately proceed to the next step.
- Fill the vehicle with the correct amount of DEF specified by the JLR approved diagnostic equipment.
- When the correct amount has been drained, position the DEF dispensing kit upper operating lever in the position indicated.
- Position the DEF dispensing kit lower operating lever in the position indicated.
- Operate the pump on the DEF dispensing kit to recover any DEF remaining in the clear filler pipe. The DEF is recovered through the inner pipe at the vehicle filler pipe. The pipe may need to be raised to assist recovery.
-
NOTE: Make sure the pump on the DEF dispensing kit is switched off before this step is completed.
Position the DEF dispensing kit lower operating lever in the position indicated.
-
CAUTION:
- If any fluid remains in the clear filler pipe after the DEF dispensing kit is disconnected from the vehicle, this must be drained and discarded before the equipment can be used again.
- Make sure that the vehicle paintwork is protected.
Disconnect the DEF dispensing kit from the DEF filler pipe.
-
CAUTION: Make sure that the mating faces are clean and free of foreign material.
Install the DEF filler cap until an audible click is heard 3 times.
- Use the JLR
approved diagnostic equipment to complete routine 0x4097 Reductant First Fill. When complete, run routine 0x4076 - Reductant Pressure Test. The ignition must stay on throughout the whole duration of these routines.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Use the JLR
approved diagnostic equipment to check the DEF
level.
General Equipment: Jaguar Land Rover approved diagnostic equipment
The following step(s) applies to:
Using JLR approved equipment: JLR-F00100010A
- Using the JLR
approved diagnostic equipment, follow the on-screen instructions and check the DEF
level.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
CAUTION: Failure to complete this instruction may cause damage to the vehicle.
Check the quality of the DEF using a hydrometer.
-
CAUTION: Failure to complete this instruction may cause damage to the vehicle.
Make sure that the inner rubber feed hose is in the position shown.
-
CAUTION:
- Make sure the DEF dispensing kit is correctly installed onto the DEF filler pipe.
- Make sure that the vehicle paintwork is protected.
Install the DEF dispensing kit on to the DEF filler pipe.
-
NOTE: Refer to the manufacturers instructions.
- Select the amount of DEF to be filled as indicated at step 24.
- Set the DEF dispensing kit to auto fill.
- Fill the vehicle with DEF .
-
CAUTION: Make sure that the vehicle paintwork is protected.
Disconnect the DEF dispensing kit from the DEF filler pipe.
-
CAUTION: Make sure that the mating faces are clean and free of foreign material.
Install the DEF tank filler cap until an audible click is heard 3 times.
- Use the JLR
approved diagnostic equipment to complete routine 0x4097 Reductant First Fill. When complete, run routine 0x4076 - Reductant Pressure Test. The ignition must stay on throughout the whole duration of these routines.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Use the JLR
approved diagnostic equipment to check the DEF
level.
General Equipment: Jaguar Land Rover approved diagnostic equipment