Inspection And Verification
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT
acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
- Verify the customer concern.
- Visually inspect for obvious signs of damage and system integrity.VISUAL INSPECTION
MECHANICAL ELECTRICAL HYDRAULIC - Damaged/stuck shift mechanism
- Damaged automatic transmission casing
- Blown fuse(s)
- Damaged, loose or corroded connectors/pins
- Wiring harness
- Fluid level too high/low
- Poor condition of fluid
- Fluid leak
- Check JLR claims submission system for open campaigns. Refer to the corresponding bulletins and SSMs which may be valid for the specific customer complaint and complete the recommendations as required.
- If the cause is not visually evident check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index.
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.