Torque Specifications
WARNING: This page is about a different variant/trim than selected.
NOTE:
Coolant must be collected into a clean container and can be reused if not contaminated.
TORQUE SPECIFICATION
| ITEM | NM | LB-FT | LB-IN |
|---|---|---|---|
| Radiator Drain Plug | 3.5 | - | 31 |
| Coolant Bleed Screws | 2 | - | 17 |
| Coolant Expansion Tank Bolt | 7 | - | 62 |
| Auxiliary Radiator Bolts | 7 | - | 62 |
| Charge Air Radiator Coolant Pump Bolt | 9 | - | 79 |
| Cooling Fan and Motor Shroud Bolts | 10 | 7 | - |
| Coolant Pump Bolts | 12 | 9 | - |
| Coolant Pump Pulley Bolts | 25 | 18 | - |
| Radiator Mounting Bracket to Body Bolts | 7 | - | 62 |
| Radiator Mounting Bracket to Radiator Bolts | 5 | - | 44 |
| Thermostat Body Bolts | 12 | 9 | - |
| Coolant Bypass Hose Bolt | 7 | - | 62 |
| Block Heater | 55 | 41 | - |
| Coolant Degas Separator | 12 | 9 | - |
LUBRICANTS, FLUIDS, SEALERS AND ADHESIVE SPECIFICATION
| COOLANT | SPECIFICATION |
|---|---|
| Coolant | Texaco Extended Life Coolant (XLC) or any glycol based coolant containing no methanol with only Organic Acid Technology (OAT) corrosion inhibitors |
| Coolant concentration - Will provide frost protection to -40°C (-40°F) | 50% (+10%/-0%) |
| Specific gravity of coolant at 20°C (68°F), to protect against frost down to -40°C (-40°F) | 1.068 |
CAPACITY SPECIFICATION
| ITEM | CAPACITY (LITERS/PINTS/US QUARTS) |
|---|---|
| Cooling system capacity | 14.7/25.8/15.5 |
| Drain volume | 7/12.3/7.4 |
| Cooling system capacity Plug-in Hybrid Electric Vehicle (PHEV) | 16.8/29.5/17.7 |
| Drain volume PHEV | 7.55/13.3/8 |
GENERAL SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Cooling Fan | 400 W |
| Cooling System Type | Pressurised, thermostatically controlled with remote header tank |
| Cooling System Type | Pressurised with integrated level sensor |
| Expansion Tank | 140 kPa |
| Pressure Cap Rating | Crossflow 27 mm core with integrated drain plug |
| Thermostat | Wax element (heated) |
| Starts To Open | 95°C (203°F) |
| Fully Open | 108°C (226°F) |