Crankshaft Pin and Bearing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Make sure that the crankshaft pin journal classification number is noted correctly, so that the correct bearing is installed.
| CRANKSHAFT PIN DIAMETER BEARING SIZE (MM) | CRANKSHAFT PIN LETTER |
|---|---|
| 55.982 - 55.988 | A - G |
| 55.989 - 55.994 | H - N |
| 55.995 - 56.000 | P - W |
| Crankshaft Pin Letter | Color |
| A - G | Brown/Yellow (Part Number - DX23-6211-BFA) |
| H - N | Brown/Red (Part Number - DX23-6211-BEA) |
| P - W | Brown/Blue (Part Number - DX23-6211-BDA) |
NOTE:
A = Refer to procedure for correct torque sequence.
TORQUE SPECIFICATION
| DESCRIPTION | NM | LB-FT | LB-IN |
|---|---|---|---|
| Engine cover mounting bolts | 10 | 7 | 88 |
| Power steering pump pulley retaining bolts | 25 | 18 | 221 |
| Power steering pump retaining bolts | 25 | 18 | 221 |
| Power steering pump bracket to engine retaining bolts | 25 | 18 | 221 |
| Generator retaining bolts | 48 | 35 | 425 |
| Starter motor retaining bolts | 48 | 35 | 425 |
| Air conditioning compressor retaining bolts | 25 | 18 | 221 |
| Engine mounting to engine mounting bracket retaining nuts | 48 | 35 | 425 |
| Engine mounting to subframe retaining nuts | 63 | 46 | 558 |
| Engine mounting bracket to engine retaining bolts | 48 | 35 | 425 |
| Crankshaft damper pulley retaining LH threaded bolt | 200 + 270° | 148 + 270° | 1770 + 270° |
| Drive plate retaining bolts | 45 + 90° | 33 + 90° | 398 + 90° |
| Exhaust manifold heat shield retaining bolts | A** | - | - |
| Exhaust manifold retaining bolts | A** | - | - |
| Engine wiring harness bracket retaining bolts | 10 | 7 | 88 |
| Coolant outlet pipe | 10 | 7 | 88 |
| Charge air cooler retaining bolts | 25 | 18 | 221 |
| Intake manifold retaining bolts | 25 | 18 | 221 |
| Oil Cooler retaining bolts | 13 | 10 | 115 |
| Knock sensor (KS) retaining bolt | 20 | 14 | 177 |
| Ignition coil retaining bolts | 8 | - | 71 |
| Spark plugs | 20 | 15 | 177 |
| Fuel rail retaining bolts | A** | - | - |
| High pressure fuel line retaining bolts | A** | - | - |
| High pressure fuel pump retaining bolts | 12 | 9 | 106 |
| Oil filter housing assembly retaining bolts | 12 | 9 | 106 |
| Oil filter cap | 28 | 21 | 248 |
| Lifting eye bolts | 25 + 90° | 18 + 90° | 221 + 90° |
| Manifold absolute pressure and temperature (MAPT) sensor retaining bolts | 5 | - | 44 |
| Coolant pump retaining bolts | 12 | 9 | 106 |
| Variable valve timing (VVT) oil control solenoid retaining bolts | 10 | 7 | 88 |
| Camshaft position (CMP) sensor retaining bolts | 10 | 7 | 88 |
| Camshaft cover retaining bolts | 13 | 10 | 115 |
| Front upper timing cover retaining bolts | 12 | 9 | 106 |
| Front lower timing cover retaining bolts | A** | - | - |
| Engine rear cover retaining bolts | A** | - | - |
| VVT to camshaft retaining bolts | 32 | 24 | 283 |
| Camshaft bearing caps retaining bolts | 11 | 8 | 97 |
| Primary timing chain fixed guide retaining bolts | 12 | 9 | 106 |
| Primary timing chain tensioner retaining bolts | 12 | 9 | 106 |
| Primary timing chain tensioner guide blade retaining bolts | 25 | 18 | 221 |
| Auxiliary chain tensioner guide retaining bolts | 21 | 15 | 186 |
| Auxiliary chain fixed guide retaining bolt | 12 | 9 | 106 |
| Oil pump sprocket retaining bolt | 25 | 18 | 221 |
| Cylinder head retaining bolts | A** | - | - |
| Engine oil level (EOL) sensor retaining bolt | 12 | 9 | 106 |
| Oil pan extension to oil pan body retaining bolts | 12 | 9 | 106 |
| Oil pan body to engine retaining bolts | 25 | 18 | 221 |
| Oil pan drain plug | 24 | 17 | 212 |
| Oil transfer tube to Oil pan body retaining bolts | 11 | 8 | 97 |
| Oil pump to cylinder block retaining bolts | 25 | 18 | 221 |
| Pick-up pipe to oil pump retaining bolts | 12 | 9 | 106 |
| Windage tray retaining bolts | 25 | 18 | 221 |
| Piston cooling jet retaining bolts | 12 | 9 | 106 |
| Cylinder block coolant draining plug | 50 | 37 | 442 |
| Balance shaft assembly retaining bolts | 25 + 90° | 18 + 90° | 221 + 90°- |
| Rear balance weight assembly retaining nuts | 25 + 38° | 18 + 38° | 221 + 38° |
| Rear balance weight assembly chain bracket retaining bolt | 25 | 18 | 221 |
| Connecting rod bolts | 20 + 125° | 14 + 125° | 177 + 125° |