Engine Oil Vacuum Draining And Filling (G1509303): Draining

WARNING: This page is about a different variant/trim than selected.

WARNING: The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.

CAUTION:

Make sure the engine is warm.
Make sure that the vehicle is parked on level ground.

NOTE: Engine oil vacuum draining and filling is the recommended procedure for engine oil change during a scheduled service. Scheduled service labour times are calculated using this method.

- Start the engine and allow to run for 10 minutes, stop the engine.
Refer to: ENGINE COVER - V6 S/C 3.0L PETROL/V8 S/C 5.0L PETROL
CAUTION: Allow 10 minutes from turning the engine off before starting oil extraction.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Loosen the element cover 4 complete turns to allow engine oil to drain from the filter cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Discard the seal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using the oil vacuum pump drain the oil out through the oil extraction tube.
  Special Tool(s): JLR-303-1644
- Remove the oil vacuum pump.