Transit Mode

All new vehicles will be delivered from the factory in transit mode. Transit mode replaces the traditional transit relay and inhibits a number of electrical systems and features to eliminate quiescent drain from the battery during delivery. Transit mode also inhibits some electrical loads when the engine is running to provide that the battery is never discharged while the engine is running.

To remove the vehicle from transit mode, the Land Rover approved diagnostic equipment must be connected during the Pre-Delivery Inspection (PDI). For additional information, Refer to: PRELIMINARY

Two jump start terminals are located adjacent to the right side top mount in the engine compartment. A cover protects the positive terminal when not in use. If jump starting is required, the cover must be removed and the positive jump lead attached securely. The cover must be equipped to the positive terminal when not in use. The negative jump lead is attached to a stud located on the right side top mount.