Roof Opening Panel Blind/Roof Opening Panel Glass Initialization
NOTE:
Roof opening panel blind/roof opening panel glass initialization will be lost if the battery is disconnected, or if the roof opening panel blind/roof opening panel glass motor power supply is interrupted whilst the roof opening panel blind/roof opening panel glass is in motion.
Initialize the roof opening panel blind/roof opening panel glass as follows:
- Start the engine and leave running during the initialization process
- Ensure that the roof opening panel blind/roof opening panel glass is in the fully closed position - press the close switch to achieve this
- Press and hold the close switch again and wait for the roof opening panel glass to jog forward a few millimeters and then return to its original position (this should take approximately 30 seconds), then release the switch
- Within 3 seconds, press and hold the close switch. The roof opening panel blind/roof opening panel glass will automatically travel toward the open position and then to the fully closed position. Release the switch when movement is complete