Roof Opening Panel Control Module Resetting

The roof opening panel control module has a non-volatile memory. If the permanent power supply to the roof opening panel control module is lost, the roof opening panel and roof blind positions are retained. The one touch feature does not require reinitializing. If the permanent power supply to the roof opening panel control module is interrupted while the roof opening panel is moving, the one touch feature must be reinitialized.

Once the power supply is restored, reset the roof opening panel mechanism as follows:

1. Set the engine to on.
2. The roof opening panel and roof blind must both be in the closed position. If not, use the front overhead console switches to close both.
3. Operate the front of the roof opening panel switch for 20 seconds until the roof blind actuates rearwards and then forwards about 10 mm.
4. Release the roof opening panel switch. Operate the front of the roof opening panel switch again within 5 seconds and keep pressed until the following sequence has completed.
   • Roof blind opens fully.
   • Roof opening panel opens fully.
   • Roof opening panel closes fully.
   • Roof blind closes fully.
5. Release the roof opening panel switch. The roof opening panel is now fully initialized.