Lower Arm - [+] Air Suspension (G2167014): Removal

CAUTION: The suspension arm nuts and bolts must be tightened with the suspension in arms in the normal ride position. Failure to follow this instruction may result in premature failure of the bush.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Before replacing the lower arm, make sure to have followed the diagnosis and testing procedure.
Refer to: SUSPENSION ARMS
Using Land Rover approved diagnostic equipment depressurize the rear spring.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Remove the wheel and tire.
Refer to: WHEEL AND TIRE
NOTE: Vehicles without Plug-in Hybrid Electric Vehicle (PHEV).

Remove the fuel tank.

Refer to: FUEL TANK - V8 S/C 5.0L Petrol

Refer to: FUEL TANK - V8 S/C 5.0L Petrol

Refer to: FUEL TANK - INGENIUM I4 2.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the suspension height sensor link.
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the stabilizer bar link.
- Discard the nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the integral link.
- Discard the nut and bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the wheel knuckle.
- Discard the nut and bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the heatshield.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the lower arm.
- Discard the nut and bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
1. Disconnect the air spring.
2. Remove the lower arm.
3. Discard the nut and bolt.