Lower Arm - [+] Air Suspension (G2167014): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
1. Install the lower arm.
2. Connect the air spring.
3. Renew the nut and bolt.
  Renew Part: Rear lower arm to subframe nut and bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 100 Nm
  
  Stage 2: 240°
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Connect the lower arm.
- Renew the nut and bolt.
  Renew Part: Rear lower arm to subframe nut and bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 100 Nm
  
  Stage 2: 240°
Install the heatshield.
Torque : 10 Nm
- Connect the wheel knuckle.
- Install and tighten a new nut and bolt.
  Renew Part: Wheel knuckle nut and bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 70 Nm
  
  Stage 2: 240°
- Connect the integral link.
- Renew the nut and bolt.
  Renew Part: Integral link nuts and bolts Quantity: 1 .
  
  Torque
  
  Stage 1: 50 Nm
  
  Stage 2: 180°
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
- Connect the stabilizer bar link.
- Renew the nut.
  Renew Part: Stabilizer bar link lower nut Quantity: 1 .
  
  Torque : 185 Nm
Connect the suspension height sensor link.
NOTE: Vehicles without PHEV .

Install the fuel tank.

Refer to: FUEL TANK - V8 S/C 5.0L Petrol

Refer to: FUEL TANK - INGENIUM I4 2.0L PETROL
Using Land Rover approved diagnostic equipment complete the air suspension manual control procedure.
Refer to: AIR SUSPENSION - MANUAL CONTROL PROCEDURE
Install the wheel and tire.
Refer to: WHEEL AND TIRE
Lower the vehicle to the floor.
Using Land Rover approved diagnostic equipment pressurize the rear spring.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE
Using Land Rover approved diagnostic equipment configure the suspension ride height.
Refer to: RIDE HEIGHT ADJUSTMENTS