PHEV Battery Changeover Valve
WARNING: This page is about a different variant/trim than selected.
| ITEM | DESCRIPTION |
|---|---|
| 1 | PHEV battery coolant outlet to the PHEV battery radiator |
| 2 | Wiring harness connector |
| 3 | PHEV battery coolant inlet |
| 4 | PHEV battery coolant outlet to the PHEV battery cooler |
The PHEV battery changeover valve is controlled by the Battery Energy Control Module (BECM). When the PHEV battery changeover valve solenoid is activated the PHEV battery coolant flows through the PHEV battery cooler. When the PHEV battery changeover valve solenoid is not activated the PHEV battery coolant flows through the PHEV battery radiator.
The PHEV battery changeover valve has a 2 pin electrical connector. The 2 pin connector has the following connections:
- A 12V signal from the BECM.
- A ground connection.