Front Silencer (G2300913): Installation

• Install but do not fully tighten the 2 rear silencer clamps.
• Install and position the rear silencers in the correct location.
• Install the rear silencer clamps into the correct position and fully tighten.

  Renew Part: Rear exhaust silencer clamp  Quantity: 2  .

  Torque  : 55 Nm 

Refer to: EXHAUST SYSTEM 

• Make sure the exhaust hanger brackets are fully installed.
• Install and tighten the 2 M8 x 35 bolts.

  Torque  : 30 Nm 

• Install and tighten the 8 M8 x 20 bolts.

  Torque  : 27.5 Nm 

• Install the front silencer clamp into the correct position and fully tighten.

  Torque  : 55 Nm