Rear Stabilizer Bar - Vehicles Without: Dynamic Suspension (G2341174): Installation

The following step(s) applies to: 

All vehicles 

1. CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
   • Install the stabilizer bar.
   • Install and tighten the 2 new nuts and bolts.

     Renew Part: Rear stabilizer bar to subframe nuts  Quantity: 2  .

     Renew Part: Rear stabilizer bar to subframe bolts  Quantity: 2  .

     Torque 

     Stage 1: 30 Nm 

     Stage 2: 84 Nm 

     Stage 3: 120 Nm 

2. • Install the 2 heatshields.
   • Install and tighten the 4 bolts.

     Torque  : 10 Nm 

3. CAUTION:

   • Nuts must be tightened with vehicle at normal ride height.
   • Use a wrench on the hexagon provided to prevent the ball joint rotating.
   NOTE:

   • LH illustration shown, RH is similar.
   • The step must be carried out on both sides.
   • Install the stabilizer bar.
   • Install and tighten the nut.

     Torque  : 185 Nm 

The following step(s) applies to: 

Vehicles with petrol engine 

1. NOTE: If equipped.
   • Install the bracket.
   • Install and tighten the 4 bolts.

     Torque  : 10 Nm 

2. NOTE: If equipped.
   • Install the cover.
   • Install and tighten the 4 nuts.
3. • With assistance, install the exhaust system.
   • Install the 2 exhaust hanger mounting rubbers.
4. Connect the electrical connector.
5. NOTE: The step must be carried out on both sides.

   Install the 2 exhaust hanger mounting rubbers.

6. Install and tighten the 2 exhaust clamps.

   Torque  : 55 Nm 

The following step(s) applies to: 

Vehicles with diesel engine 

1. Install the rear silencer.

   Refer to: REAR SILENCER

The following step(s) applies to: 

All vehicles 

1. Install the rear air spring.

   Refer to: REAR AIR SPRING