LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2019 >> Range Rover Sport HSE Dynamic >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM I6 3.0L Petrol -- Range Rover Sport/L494 >> Engine Cooling - INGENIUM I6 3.0L Petrol >> Diagnosis And Testing >> Engine Cooling - INGENIUM I6 3.0L Petrol (G2297094) >> Symptom Chart

Symptom Chart

Symptom Possible Causes Action
  • Coolant loss
  • Coolant leak
    • Hoses
    • Hose connections
    • Radiator
    • Coolant pump
    • Heater core
    • Gaskets
    • Engine casting cracks
    • Cylinder block core plugs
  • Perform a visual inspection. If there are no obvious leaks, perform a cooling system pressure test. Rectify any leaks as necessary
  • Engine overheats
  • Low/contaminated coolant
  • Thermostat stuck closed
  • Cooling fan failure
  • Radiator airflow restricted
  • Engine management system fault
  • Inspect the coolant level and condition. Complete a cooling system pressure test. Rectify as necessary
  • Inspect the thermostat and rectify as necessary
  • Inspect the operation of the viscous fan. Rectify as necessary
  • Inspect the radiator for obstructions to the airflow. Rectify as necessary.
  • Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTC  s and refer to the relevant DTC  index
  • Engine not reaching normal temperature
  • Thermostat stuck open
  • Cooling fan failure
  • Inspect the thermostat and rectify as necessary
  • Inspect the operation of the viscous fan. Rectify as necessary
  • No or low coolant flow in the cooling system with the following DTC  s set
    • P023A
    • P023B
    • P023C
    • P2B83
    • P2B84
    • P026E
    • P2BC2
  • Low coolant or coolant flow restriction
  • Poor or damaged wiring or connections
  • Water ingress in to the wiring harness or connectors
  • Fuse failure
  • Powertrain control module or calibration fault
  • Power supply. Battery, charging system or ground fault
  • Variable coolant pump failure
  • Complete the variable coolant pump pinpoint test in this article. GO to PINPOINT TEST A .