| Poor performance (off-boost) |
- Low/contaminated fuel
- Intake pipe restricted/blocked
- General engine condition
- Engine system fault
|
- Check the fuel level and condition. Draw off approximately 1 ltr (2.11 pints) of fuel and allow to stand for 1 minute. Check to make sure there is no separation of the fuel indicating water or other liquid in the fuel. Rectify as necessary
- Check the intake pipe for restrictions and blockages. Rectify as necessary
- Check the engine condition, compressions, etc, if there are indications of a mechanical fault. Rectify as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTC
s and refer to the relevant DTC
index
|
| No boost |
- Electrical connections and harnesses
- Intake pipe disconnected/damaged after the air cleaner
- Intake pipe restricted/blocked
- Charge air cooler restricted/leaking
- Turbocharger actuator failure(s)
- Turbocharger failure(s)
- Engine system fault
|
- Check the electrical connections and harnesses. Rectify as necessary
- Check the intake system for correct installation and damage. Rectify as necessary
- Check the intake pipe for restrictions and blockages. Rectify as necessary
- Check the turbocharger actuators and circuits. Rectify as necessary
- Check the turbochargers for wear. Disconnect the turbocharger intake and outlet pipework and turn the turbochargers by hand. Any roughness indicates a fault. Check any up and down movement in the turbocharger shafts. Excessive movement indicates a fault. If in doubt, compare the unit with a new turbocharger. Rectify as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the powertrain control module for related DTC
s and refer to the relevant DTC
index
|
| No boost/excessive noise |
|
- Disconnect the turbocharger intake and outlet pipework and turn the turbochargers by hand. Any roughness indicates a fault. Check any up and down movement in the turbocharger shafts. Excessive movement indicates a fault. If in doubt, compare the unit with a new turbocharger. Rectify as necessary
|
| Oil on the turbocharger assembly |
- Oil leak from connection(s) to the turbocharger assembly
- Oil leak from engine above the turbocharger
- Slight oil trace from the joint between turbocharger assembly and exhaust downpipe (RH Secondary Turbocharger)
|
NOTE:
DO NOT replace the turbocharger for an oil leak issue until investigations have been made to establish the source of the oil leak. In most cases it is NOT the turbocharger that is at fault.
- Clean all oil residue from the turbocharger assembly and check for leaks from the oil feed and drain joints. Replace copper washers and gaskets as necessary. Refer to: RIGHT TURBOCHARGER (G2131202)
Removal steps 9, 14 and installation steps 6, 10. Check and top up the engine oil as necessary. Perform a road test and check no oil leaks are evident
- Clean all oil residue from the turbocharger assembly. Check for leaks from the inlet manifold/camshaft covers. Inspect the front and rear joints between the Inlet manifold/camshaft covers and cylinder heads. If a leak is evident, install a new camshaft cover gasket to the leaking side only as necessary Refer to: LEFT VALVE COVER
or RIGHT VALVE COVER
Check and top up the engine oil as necessary. Perform a road test and check no oil leaks are evident
-
NOTE:
DO NOT replace the turbocharger assembly for this possible cause, unless there are DTC
s set and the vehicle has drivability issues. A small trace of oil is normal if the vehicle has light use or is used on short journeys.
Clean all oil residue from the turbocharger assembly. Check and top up the engine oil as necessary. Perform a road test and check for traces of oil. If no oil traces are evident, return the vehicle to the customer
|