Intake Air Shutoff Throttle (G1879758): Installation
- Make sure that 3 new seals are fitted to the intake air shut-off throttle.
Renew Part: Intake air shutoff throttle seals Quantity: 1 .
- Install the intake air shut-off throttle into the correct position, Make sure that the seals are not damaged during installation.
- Install the intake air shut-off throttle retaining nut and tighten to the correct torque.
Torque : 10 Nm
- Connect the intake air shut-off throttle upper electrical connector.
- NOTE: Only carry out this step if previously removed.
Install the Exhaust Gas Recirculation (EGR) inlet pipe into the intake air shut-off throttle. Make sure that a new EGR pipe clamp is installed.
Renew Part: EGR valve inlet tube clamp Quantity: 1 .
- Install the EGR valve outlet tube.
- Install the 4 vacuum hoses into the correct position and secure with the retaining clip.
- Connect the intake air shut-off throttle lower electrical connector.
- Install the air pipe and tighten the air pipe clamp to the correct torque.
Torque : 3.2 Nm
-
- Install and tighten the two air pipe retaining bolts.
Torque : 5 Nm
- Connect the electrical connector and the breather onto the air pipe.
- Install and tighten the two air pipe retaining bolts.
- Install the engine cover.
Refer to: ENGINE COVER - TDV6 3.0L DIESEL
- If a new intake air shut-off throttle has been installed, configure using the approved diagnostic tool.
General Equipment: LandRover approved diagnostic tool