LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar First Edition >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake -- Range Rover Velar/L560 >> Rear Disc Brake >> Removal And Installation >> Brake Hose (G2561002) >> Installation

Brake Hose (G2561002): Installation

  1. CAUTION: Make sure that the brake hose is not twisted and is correctly located.
    NOTE: The flexible brake hose with washers and the banjo bolt is only available as an assembly.
    • Install a new brake hose assembly.
    • Install and tighten the banjo bolt.

      Torque  : 32 Nm 

    • Install the retaining clip.
    • Connect the brake pipe unions.

      Torque  : 15 Nm 

  2. Bleed the brake system.

    Refer to: BRAKE SYSTEM BLEEDING

  3. Install the wheel and tire.

    Refer to: WHEEL AND TIRE

scientia non olet · About LEMON Manuals