Brake Caliper (G2131600): Removal

CAUTION:

Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

Connect the diagnostic tool and set the Electric Park Brake (EPB) to the maintenance position.
Release the park brake cable tension.
NOTE: This step is only required if the diagnostic tool is not available.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
Release the electric park brake.
NOTE: This step is only required if the vehicle has no battery power.

Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the wheel and tire.
Refer to: WHEEL AND TIRE
Remove the brake pad spring clip.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness.
Remove the banjo bolt.
CAUTION:
- Inspect the brake hose sealing washers for signs of damage, if damage is present discard the sealing washers.
- Be prepared to collect escaping fluids.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Be prepared to collect escaping fluids.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the brake pipe union.
- Remove the retaining clip.
- Remove the brake hose.
Remove the brake caliper.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Remove the EPB actuator.
CAUTION: Remove and discard the O-ring seal.

NOTE: Only carry out the following step(s) if the new component is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Electric park brake actuator O-ring seal Quantity: 1 .