Brake Vacuum Pump - V8 S/C 5.0L Petrol (G2264160): Removal
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Drain the engine oil.
Refer to the appropriate Enginge System article
- Remove the undershield.
Refer to: ENGINE UNDERSHIELD
- Disconnect the vacuum pipe.
- Remove the 2 M6 x 65 bolts.
- Remove the brake vacuum pump.
- Remove and discard the vacuum pump seal.