LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar First Edition >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Power Brake Actuation -- Range Rover Velar/L560 >> Power Brake Actuation (G2318565) >> Removal And Installation >> Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669) >> Installation

Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669): Installation

  1. NOTE: Only carry out this step if previously removed.

    Install the oil pick-up pipe and tighten the bolts to the correct torque.

    Torque  : 12 Nm 

  2. Install the brake vacuum pump assembly and tighten the bolts to the correct torque.

    Torque  : 25 Nm 

  3. Install the oil pump wiring harness.
  4. Connect the electrical connector for the oil pump.
  5. Install the oil pump chain.

    Refer to: OIL PUMP CHAIN

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals