LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Engine - TDV6 3.0L Diesel (G2297235) >> Removal And Installation >> Left Engine Mount (G2131800) >> Installation

Left Engine Mount (G2131800): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the engine mount.
  2. Lower the engine on to the engine mount.
  3. NOTE: Hand tighten the nut and bolts at this stage.
    • Install the engine mount blots.
    • Install the engine mount nut.
  4. Remove the stand and wooden block.
  5. Full tighten the engine mount nut and bolts.

    Torque 

    Nut: 60 Nm 

    Bolt: 60 Nm 

  6. Connect the vacuum tube.
  7. Install the Air Conditioning (A/C) compressor.

    Refer to: AIR CONDITIONING COMPRESSOR - TDV6 3.0L DIESEL

  8. Connect the startup battery ground cable.

    Refer to: AIR CONDITIONING COMPRESSOR - TDV6 3.0L DIESEL

scientia non olet · About LEMON Manuals