Crankshaft Pin and Bearing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Make sure that the crankshaft pin journal classification number is noted correctly, so that the correct bearing is installed.
| CRANKSHAFT PIN DIAMETER BEARING SIZE (MM) | CRANKSHAFT PIN LETTER |
|---|---|
| 55.982 - 55.988 | A - G |
| 55.989 - 55.994 | H - N |
| 55.995 - 56.000 | P - W |
| Crankshaft Pin Letter | Color |
| A - G | Brown/Yellow (Part Number - DX23-6211-BFA) |
| H - N | Brown/Red (Part Number - DX23-6211-BEA) |
| P - W | Brown/Blue (Part Number - DX23-6211-BDA) |
TORQUE SPECIFICATION
| DESCRIPTION | NM | LB-FT | LB-IN |
|---|---|---|---|
| Engine cover mounting bolts | 10 | 7 | 84 |
| Accessory drive belt tensioner retaining bolt | 40 | 29.5 | 354 |
| Supercharger belt idler/tensioner bracket retaining bolts | 25 | 18.5 | 222 |
| Secondary drive belt idler retaining bolts | 40 | 29.5 | 354 |
| Power steering pump pulley retaining bolts | 25 | 18.5 | 222 |
| Power steering pump retaining bolts | 25 | 18.5 | 222 |
| Power steering pump bracket to engine retaining bolts | 25 | 18.5 | 222 |
| Generator retaining bolts | 48 | 35.5 | 426 |
| Starter motor retaining bolts | 48 | 35.5 | 426 |
| Air conditioning compressor retaining bolts | 25 | 18.5 | 222 |
| Engine mounting to engine mounting bracket retaining nuts | 60 | 44 | 528 |
| Engine mounting to subframe retaining nuts | 60 | 44 | 528 |
| Engine mounting bracket to engine retaining bolts | 48 | 35.5 | 426 |
| Crankshaft damper pulley retaining LH threaded bolt | - | - | - |
| Stage 1 | 200 | 148 | 1776 |
| Stage 2 | 270° | - | - |
| Flexplate retaining bolts | - | - | - |
| Stage 1 | 45 | 33 | 396 |
| Stage 2 | 90° | - | - |
| Exhaust manifold heat shield retaining bolts | 3 | 2 | 24 |
| Exhaust manifold retaining bolts | 18 | 13 | 156 |
| Engine wiring harness bracket retaining bolts | 10 | 7 | 84 |
| Coolant outlet pipe | 10 | 7 | 84 |
| Intercooler retaining bolts | 25 | 18.5 | 222 |
| Intake manifold retaining bolts | 25 | 18.5 | 222 |
| Oil cooler retaining bolts | - | - | - |
| Stage 1 | 7 | 5.1 | 61 |
| Stage 2 | 12 | 9 | 108 |
| Knock sensor (KS) retaining bolt | 20 | 15 | 180 |
| Ignition coil retaining bolts | 8 | 6 | 72 |
| Spark plugs | 20 | 15 | 180 |
| Fuel rail retaining bolts | 20 | 15 | 180 |
| High pressure fuel pipe retaining bolts | 30 | 22 | 264 |
| High pressure fuel pump retaining bolts | 12 | 9 | 108 |
| Oil filter housing assembly retaining bolts | 12 | 9 | 108 |
| Oil filter cap | 28 | 21 | 252 |
| Lifting eye bolts | - | - | - |
| Stage 1 | 25 | 18 | 222 |
| Stage 2 | 90° | - | - |
| Manifold Absolute Pressure and Temperature (MAPT) sensor retaining bolts | 5 | 3.5 | 42 |
| Coolant pump retaining bolts | 12 | 9 | 108 |
| Variable Valve Timing (VVT) oil control solenoid retaining bolts | 10 | 7 | 84 |
| Camshaft position (CMP) sensor retaining bolts | 10 | 7 | 84 |
| Valve cover retaining bolts | 13 | 10 | 120 |
| Front upper timing cover retaining bolts | 12 | 9.5 | 114 |
| VVT to camshaft retaining bolts | 32 | 23.5 | 282 |
| Camshaft bearing caps retaining bolts | 12 | 8 | 96 |
| Primary timing chain fixed guide retaining bolts | 12 | 9 | 108 |
| Primary timing chain tensioner retaining bolts | 12 | 9 | 108 |
| Primary timing chain tensioner guide blade retaining bolts | 25 | 18.5 | 222 |
| Auxiliary chain tensioner guide retaining bolts | 21 | 15.5 | 186 |
| Auxiliary chain fixed guide retaining bolt | 12 | 9 | 108 |
| Oil pump sprocket retaining bolt | 25 | 18.5 | 222 |
| Oil pump electrical connector retaining bolt | 12 | 9 | 108 |
| Cylinder head retaining bolts M10 | - | - | - |
| Stage 1 | 20 | 15 | 180 |
| Stage 2 | 35 | 26 | 312 |
| Stage 3 | 35 | 26 | 312 |
| Stage 4 | 35 | 26 | 312 |
| Stage 5 | 90° | 90° | 90° |
| Stage 6 | 120° | 120° | 120° |
| 3 cylinder head retaining bolts | 25 | 18.5 | 222 |
| 2 cylinder head retaining bolts | 12 | 9 | 108 |
| Engine Oil Level (EOL) sensor retaining bolt | 12 | 9 | 108 |
| Oil pan to oil sump body retaining bolts | 12 | 9 | 108 |
| Oil sump body to engine retaining bolts | 25 | 18.5 | 222 |
| Oil pan drain plug | 24 | 18 | 216 |
| Oil transfer tube to Oil pan body retaining bolts | 11 | 8 | 96 |
| Oil pump to engine block retaining bolts | 25 | 18.5 | 222 |
| Pick-up pipe to oil pump retaining bolts | 12 | 9 | 108 |
| Windage tray retaining bolts | 25 | 18.5 | 222 |
| Piston cooling jet retaining bolts | 12 | 9 | 108 |
| Engine block coolant draining plug | 50 | 37 | 444 |
| Balance shaft assembly retaining bolts | - | - | - |
| Stage 1 | 25 | 18.5 | 216 |
| Stage 2 | 90° | - | - |
| Rear balance weight assembly retaining nuts | - | - | - |
| Stage 1 | 25 | 18.5 | 222 |
| Stage 2 | 30° | - | - |
| Rear balance weight assembly chain bracket retaining bolt | 25 | 18.5 | 222 |
| Connecting rod bolts | - | - | - |
| Stage 1 | 20 | 15 | 180 |
| Stage 2 | 125° | - | - |
| Camshaft bearing caps | - | - | - |
| Stage 1 | 3 | 2.2 | 26.5 |
| Stage 2 | 12 | 9 | 108 |
| Crankshaft pulley bolt: | - | - | - |
| Stage 1 | 200 | 147.5 | 1770 |
| Stage 2 | 200° | - | - |
| Rear Crankshaft cover retaining bolts | 11 | 8 | 96 |
| Exhaust sensor | 45 | 33 | |
| Exhaust manifold heat cover retaining bolts | 3 | 2.2 | 26.5 |
| Oil filter | 25 | 18.5 | 222 |
| Fuel pump camshaft retaining bolts | 12 | 9 | 108 |
| Oil pump sprocket | 12 | 9 | 108 |
| Oil level sensor | 11 | 8 | 108 |
| Engine mount bracket to engine block | 40 | 29.5 | 354 |
| Crankshaft front seal | 26 | 19 | 228 |
| Crankshaft pulley retaining bolts | 65 | 48 | 576 |
| Rear oil seal plate retaining bolts | 11 | 8 | 96 |
| Oil pump chain tensioner retaining bolt | 21 | 15.5 | 186 |
| Catalyst monitor sensor | 45 | 33 | 396 |
| Lower timing cover M6 | 12 | 9 | 108 |
| Lower timing cover M8 | 20 | 15 | 180 |
| Oil filter housing | 25 | 18.5 | 222 |
| Oil level sensor | 11 | 8 | 96 |
| Oil pan retaining bolts | 25 | 18.5 | 222 |
| GPF Sensor banjo bolt | 25 | 18.5 | 222 |
| GPF bracket nuts | 12 | 9 | 108 |