Coolant Pump - Charge Air Cooler (G2132748): Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
Cooling fans may continue to operate after the engine is turned off. They may also start to operate after the engine is turned off and continue operating for up to 10 minutes.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD
- Drain the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Disconnect the charge air cooler coolant pump electrical connector.
-
CAUTION: Be prepared to collect escaping coolant.
Release the lower charge air cooler coolant pump hose and reposition away from the pump assembly.
-
CAUTION: Be prepared to collect escaping coolant.
Release the upper charge air cooler coolant pump hose and reposition away from the pump assembly.
Remove the charge air cooler coolant pump and bracket from the vehicle.
-
NOTE: Do not disassemble further if the component is removed for access only.
Remove the charge air cooler coolant pump bracket from the pump assembly