Auto Stop/Start Warning Indicator
WARNING: This page is about a different variant/trim than selected.
The auto stop/start warning indicator is located in the Instrument Cluster (IC). The warning indicator illuminates when the engine stops during a stop/start cycle, then expire when the engine restarts. To illuminate the auto stop/start warning indicator, the Powertrain Control Module (PCM) sends a signal to the Body Control Module/Gateway Module (BCM/GWM) assembly via the FlexRay bus. The BCM/GWM assembly transmits the request signal to the IC via the High Speed (HS) Controller Area Network (CAN) comfort systems bus.