LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Exhaust System - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Exhaust System - TDV6 3.0L Diesel >> Diagnosis And Testing >> Exhaust System - TDV6 3.0L Diesel (G1899143) >> Symptom Chart

Symptom Chart

WARNING: This page is about a different variant/trim than selected.
SYMPTOM POSSIBLE CAUSES ACTION
  • Engine malfunction lamp illuminated
  • Or 
  • Reagent indicator (17MY on)
  • Selective catalyst reduction system failure
  • Diesel exhaust fluid level too low
  • Power or ground failure
  • Diesel exhaust fluid pressure too low
  • Diesel exhaust fluid pressure too high
  • Diesel exhaust fluid injection pump
  • Diesel exhaust fluid injector
  • Diesel exhaust fluid relay
  • Diesel exhaust fluid heater control unit
  • Pre selective catalytic reduction NOx sensor
  • Pre selective catalyst reduction NOx sensor module
  • Post selective catalyst reduction NOx sensor
  • Post selective catalyst reduction NOx sensor module
  • Post selective catalyst reduction Particulate Matter Sensor
  • Post selective catalyst reduction Particulate Matter Sensor module
  • Diesel sub net Controller Area Network (CAN) communication bus
  • Using the Jaguar Land Rover Approved Diagnostic Equipment check powertrain control module for related Diagnostic Trouble Code(s) and refer to relevant DTC index
  • Check and correct the diesel exhaust fluid level
  • Refer to the appropriate system wiring diagrams and check connections are secure and wiring integrity
  • Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Refer to the appropriate system wiring diagrams and check sensor, relays/fuses and control module power feeds and grounds
  • Check system for correct installation of components
  • Check system mechanical and fluid integrity
  • Check system for mechanical integrity
  • Check system for leakage
  • Check system for blockage
  • Engine will not crank
  • Vehicle battery failure
  • Diesel exhaust fluid level too low or empty
  • Harness failure - Wiring integrity
  • Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Check and correct the diesel exhaust fluid level
  • Using the Jaguar Land Rover Approved Diagnostic Equipment complete Service Functions - Reset Selective Catalyst Reduction Start Inhibit
  • Message warning and/or DEF  warning symbol is illuminated
  • Selective catalyst reduction system failure
  • A monitor of the historical diesel exhaust fluid consumption rate, allied with a direct reading of the diesel exhaust fluid level in the tank, predicts that the distance to emptying the tank is less than 2400km
  • Using the Jaguar Land Rover Approved Diagnostic Equipment check powertrain control module for related Diagnostic Trouble Code(s) and refer to relevant DTC index
  • Check and correct the diesel exhaust fluid level
  • The DEF  warning symbol illumination has 3 different colors which is determined by fluid level in the tank. For further information on the DEF  warning symbols, refer to DEF  Level found further down this page