Exhaust Rear Section

WARNING: This page is about a different variant/trim than selected.

The exhaust rear section comprises a single intermediate pipe, which separates into 2 pipes that connect to the rear silencer assemblies. The exhaust rear section is connected to the exhaust center section with a clamp.

The intermediate pipe comprises an exhaust pressure control valve. For additional information, Refer to: ENGINE EMISSION CONTROL

The intermediate pipe is supported by 2 hanger brackets, each with a mounting rubber connected to a common bracket which are bolted to the vehicle body.

Each rear silencer has an inlet pipe and an outlet pipe.

Each rear silencer inlet pipe is secured to the intermediate pipe by a clamp.

Each rear silencer is supported by 2 mounting rubbers. A mounting rubber is attached to a mounting welded on the side of the rear subframe and the other is attached to a bracket bolted to the vehicle body.