LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Glow Plug System - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Glow Plug System - TDV6 3.0L Diesel >> Diagnosis And Testing >> Glow Plug System - TDV6 3.0L Diesel (G1426644) >> Symptom Chart

Symptom Chart

WARNING: This page is about a different variant/trim than selected.
SYMPTOM POSSIBLE CAUSES ACTION
Engine difficult to start (in extreme cold ambient temperature)
  • Engine system fault
  • Glow plugs inoperative/inefficient
  • Fuel temperature too low (causing waxing)
  • Using the manufacturer approved diagnostic system, check the powertrain control module for related DTCs and refer to the relevant DTC index
  • Check the operation of the glow plugs
  • The fuel system recycles fuel until operating temperature is reached to reduce this possibility
Cold engine emissions excessively high
  • Engine system fault
  • Glow plug after-glow phase inoperative
NOTE: The glow plug after-glow phase is designed to function at engine temperatures below 50°C (122°F), and below 2500 rpm.
  • Using the manufacturer approved diagnostic system, check the powertrain control module for related DTCs and refer to the relevant DTC index
  • Check the operation of the glow plugs
Cold engine noise, vibration or harshness excessive
  • Engine system fault
  • Glow plug after-glow phase inoperative
NOTE: The glow plug after-glow phase is designed to function at engine temperatures below 50°C (122°F), and below 2500 rpm.
  • Using the manufacturer approved diagnostic system, check the powertrain control module for related DTCs and refer to the relevant DTC index
  • Check the operation of the glow plugs