Pinpoint Test A: Smart Key Not Found - Refer To Handbook
WARNING: This page is about a different variant/trim than selected.
- A1: IGNITION MODE FAILS TO SWITCH ON NOTE:
- In normal operation, pressing the start button for one second will cause the vehicle to enter the ignition mode. If the procedures below are followed the engine should crank
- For automatic transmission vehicles, ensure the brake pedal is depressed and the park or neutral selected
- Ensure the smart key is within the cabin area. Check the smart key is not close to any electrical devices e.g. Smart phones, laptops, laptop cases, games consoles and game console bags, briefcases, metal objects etc. All can affect the system performance and may block its communication with the vehicle. If the smart key battery low warning message has been displayed it is likely that the smart key battery has insufficient charge. Refer to PINPOINT TEST B: BACK UP START - 10MY ONWARDS - SMART KEY NOT FOUND - REFER TO HANDBOOK
Has the vehicle started?
Yes: No further action required
No: Check and install a new battery as required. Clear the DTC and retest. If the problem persists, contact dealer technical support