Rear Coolant Manifold (G2368790): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 6 bolts.
  Torque : 9 Nm
Install the wiring harness clip to the left side of the rear coolant manifold.
- Connect the electrical connector.
- Install the 2 wiring harness clips to the right side of the rear coolant manifold.
- Connect the rear coolant manifold left hose.
- Install the coolant hose clip.
Connect the right side coolant hose.
- Reposition the wiring harness into the correct location.
- Install and tighten the 2 bolts.
  Torque : 9 Nm
Install the vacuum pipe to the clip.
Install the secondary bulkhead right panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL - V6 S/C 3.0L PETROL
Install the secondary bulkhead left panel.
Refer to: SECONDARY BULKHEAD LEFT PANEL - V6 S/C 3.0L PETROL
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING