LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Engine Vent Oil Separator (G2356994) >> Installation

Engine Vent Oil Separator (G2356994): Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. NOTE: Inspect the seals, Replace if damaged.

    Install the valve cover vent oil separator.

    Renew Part: Crankcase oil vent oil separator to cylinder block seals Quantity: 1  .

    Torque  : 12 Nm 

  3. Install the fuel injector wiring harness and secure in position with the 3 retaining clips.
  4. Install the breather pipe onto the valve cover vent oil separator.
  5. Install the Noise, Vibration and Harshness (NVH) pad.
  6. Install the engine cover.
scientia non olet · About LEMON Manuals