LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Diesel Exhaust Fluid Injector (G1899120) >> Installation

Diesel Exhaust Fluid Injector (G1899120): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install a new gasket to the DEF  injector.

      Renew Part: Diesel exhaust fluid injector refit kit Quantity:  .

    • Install the DEF  injector.
    • Install and tighten the clamp.

      Torque  : 5 Nm 

    • Connect the DEF  injector electrical connector.
    • Reposition the DEF  injector electrical connector cover.
    • Connect the DEF  injector supply pipe.
    • Reposition the DEF  injector supply pipe heatshield.
  1. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  2. NOTE: SRO to be claimed separately.
    • Connect the Jaguar Land Rover (JLR) approved diagnostic equipment.

      General Equipment: Jaguar Land Rover approved diagnostic equipment 

    • Select 'Powertrain - Diesel Exhaust Fluid Prime and Pressure Test' from the diagnostic menu.
    • Make sure that all steps from the on-screen instructions are followed.