LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Diesel Exhaust Fluid Injection Pump (G1937876) >> Removal

Diesel Exhaust Fluid Injection Pump (G1937876): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Drain the Diesel Exhaust Fluid (DEF).

    Refer to: DIESEL EXHAUST FLUID TANK DRAIN AND REFILL 

  3. WARNING: Be prepared to collect escaping fluid.
    G11698751Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector and the DEF  fluid pipe.

  4. CAUTION: Make sure that all disconnected electrical connectors and sockets are sealed.
    G11698752Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector.

  5. G11698753Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove and discard the DEF  pump bolts.

  6. WARNING: Be prepared to collect escaping fluid.
    CAUTION: Do not use excessive force to remove the component.
    G11698754Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Using a suitable tool remove the DEF  pump.

  7. CAUTION: Using a suitable tool, remove the seals.
    NOTE: If a new pump is being installed this step is not required.
    G11698755Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove and discard the DEF  pump seals.