LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Removal And Installation >> Post DPF Exhaust Gas Temperature Sensor (G1208496) >> Removal

Post DPF Exhaust Gas Temperature Sensor (G1208496): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Remove the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  3. CAUTION: Take extra care not to damage the wiring harnesses.
    G14289959Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector.

  4. Remove the heated oxygen sensor.

    Torque  : 35 Nm 

scientia non olet · About LEMON Manuals