LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Removal And Installation >> Post Catalytic Converter Temperature Sensor (G1887680) >> Installation

Post Catalytic Converter Temperature Sensor (G1887680): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: If accidentally dropped or knocked install a new sensor.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

    Using the special tool, install the post catalytic converter temperature sensor.

    Special Tool(s): 310-121 

    Torque  : 48 Nm 

  2. Connect the electrical connector and secure the retaining clip.
  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals