LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Pre Selective Catalyst Reduction NOX Sensor (G2272465) >> Installation

Pre Selective Catalyst Reduction NOX Sensor (G2272465): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the pre Selective Catalyst Reduction (SCR) NOx sensor.
    • Use the special tool to install the pre SCR NOx sensor

      Special Tool(s): JLR-303-1666 

      Torque  : 60 Nm 

  3. Install the wiring harness to the 4 clips.
    • Install the pre SCR NOx sensor module.
    • Connect the electrical connector.
    • Install the wiring harness to the clip.
  5. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals