LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Pre DPF Exhaust Gas Temperature Sensor (G1851721) >> Installation

Pre DPF Exhaust Gas Temperature Sensor (G1851721): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the anti-seize compound meeting specification ESE-M12A4-A is applied only to the threaded section and does not contact the sensor body.

    Install the pre Diesel Particulate Filter (DPF) exhaust gas temperature sensor.

    Torque  : 35 Nm 

  2. Connect and secure the pre DPF exhaust gas temperature sensor wiring harness.
  3. Install the engine cover.
scientia non olet · About LEMON Manuals