LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Post Selective Catalyst Reduction NOX Sensor (G2272464) >> Installation

Post Selective Catalyst Reduction NOX Sensor (G2272464): Installation

WARNING: This page is about a different variant/trim than selected.
    • Use the special tool to install the post Selective Catalyst Reduction (SCR) NOx sensor.

      Special Tool(s): JLR-303-1666 

      Torque  : 60 Nm 

  2. Install the wiring harness to the 2 clips.
    • Install the post SCR NOx sensor module.
    • Connect the electrical connector.
    • Install the right side undershield.
    • Install the 9 fasteners.
    • Install and tighten the 6 bolts.

      Torque  : 7 Nm 

    • Install and tighten the 3 nuts.

      Torque  : 7 Nm 

    • Install the wheel arch air deflector.
    • Install the 3 fasteners.
    • Install the rear undershield.
    • Install and tighten the 2 nuts.

      Torque  : 7 Nm 

    • Install and tighten the 4 bolts.

      Torque  : 7 Nm 

scientia non olet · About LEMON Manuals