LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Heated Oxygen Sensor (G1947563) >> Installation

Heated Oxygen Sensor (G1947563): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • If accidentally dropped or knocked install a new Heated Oxygen Sensor (HO2S).
    • Make sure the HO2S sensor wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    • If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor. Make sure the anti-seize compound does not contact the HO2S tip.

    Use the special tool to install and tighten the Heated Oxygen Sensor (H02S).

    Special Tool(s): JLR-303-1666 

    Torque  : 48 Nm 

    • Connect the H02S electrical connector.
    • Install the clip.
  3. Install the secondary bulkhead left panel.

    Refer to: SECONDARY BULKHEAD LEFT PANEL - INGENIUM I4 2.0L DIESEL

  4. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL

scientia non olet · About LEMON Manuals