LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Diesel Exhaust Fluid Heater Control (G2207005) >> Installation

Diesel Exhaust Fluid Heater Control (G2207005): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the diesel exhaust fluid heater control.
    • Install the retaining bolt.

      Torque  : 7 Nm 

    • Connect the electrical connector.
  2. Install the loadspace trim scuff panel.
  3. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals