LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Diagnosis And Testing >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1923233) >> Drive Cycle: Particulate Matter (Pm) Sensor Monitors >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - OBD II Readiness Tests.
  2. Drive the vehicle steadily at a speed of approximately 50 mph (80 km/h) for a minimum of 10 minutes.
NOTE: If a gear shift occurs during this step, the step must be repeated. To avoid gear shifts, manual gear selections or 3rd or 4th gear may be used.
  1. Perform three or more sharp accelerations, followed by fuel cut off:
    1. Drive the vehicle at a speed of approximately 55 mph (88 km/h) and select 4th gear.
    2. Accelerate gently and then release the accelerator pedal to trigger fuel cut off. Do not press the accelerator pedal or brake pedal for a duration of 5 seconds.
  2. Using the Jaguar Land Rover approved diagnostic equipment, check the readiness status of the exhaust gas sensors monitor.
scientia non olet · About LEMON Manuals